INSTALLATION MODE SELECTION
1
Press and release
programming button
to select installation mode.
2
Press and hold
programming button
until LED turns solid GREEN
to register selection.
!
After registration, follow Factory Reset Procedure to
change installation mode and restart this procedure.
LED fl ashes (1X) once = DATA MODE
LED fl ashes (2X) twice = STANDARD HARDWIRE MODE
TYPE 2 - MODULE PROGRAMMING PROCEDURE - 1 OF 2
1
Insert key 1 into ignition.
2
Turn key 1 to ON position.
ON
!
If the module’s LED begins to fl ash RED, verify the RX
and TX connections between the module and the vehicle.
!
If the module’s LED turns solid GREEN for 2 seconds,
the Module Programming Procedure is completed.
NOTE
I
To complete this procedure,
both OEM keys are required.
5
Remove key 1.
6
Insert key 2 into ignition.
7
Turn key 2 to ON position.
ON
8
Wait, LED will turn solid RED
then will turn OFF.
3
Wait, LED will turn solid RED
then will turn OFF.
10
Press and release programming
button.
IMPORTANT: READ NEXT PAGE !
9
TIME RESTRICTI
N
Complete steps 9 to 11
within 5 SECONDS.
Turn key 2 to OFF position.
OFF
4
Turn key 1 to OFF position.
OFF
TIME RESTRICTI
N COMING UP !
Page 9 of 11
FLC-AL(TB)-FM3-EN
20140116
iNstall Guide
www.flash-it.com
audiovox electronics corp. © 2013
Transponder Bypass
Ford/LincoLn
Doc. No.: ##13459##
