Flashcut CNC Pro Series, Руководство по оборудованию

Страница: 25 / 59

FlashCut CNC Section 5 Signal Generator 25
The Axis plug-in interfaces are used to add additional functions to the main signal
generator board. For example, a stepper drive plug-in card or cable will enable
you to drive a stepper motor directly from the signal generator box.
1 2
3 4
5 6
7 8
9 10
11 12
13 14
15 16
17 18
19 20
Each of these plug-in cards is a SKT10X2 connector, with the
pin configuration on the left. Pin numbers 1-5, 7, 13, 15 and
17-20 perform the same function on each jumper.
Per the chart below, pins 6, 8-12, 14 and 16 have different
values of Status, Fault, InputA, Dir, InputB, Step, SCOM and
CS respectively for each plug-in card.
Pin
No.
Label Function JP-71 JP-72 JP-73 JP-74 JP-75
1 HV-PWR High Voltage Power HV-PWR HV-PWR HV-PWR HV-PWR HV-PWR
2 HV-PWR High Voltage Power HV-PWR HV-PWR HV-PWR HV-PWR HV-PWR
3 GND Ground GND GND GND GND GND
4 GND Ground GND GND GND GND GND
5 RxD2 Serial Com. Receive RxD2 RxD2 RxD2 RxD2 RxD2
6 STATUS Status STATUS1 STATUS2 STATUS3 STATUS4 STATUS5
7 TxD2 Serial Com. Transmit TxD2 TxD2 TxD2 TxD2 TxD2
8 FAULT Fault Indicator FAULT1 FAULT2 FAULT3 FAULT4 FAULT5
9 INPUTA Input A IN8 IN10 IN12 IN14 IN16
10 DR Direction DR1 DR2 DR3 DR4 DR5
11 INPUTB Input B IN9 IN11 IN13 IN15 IN17
12 ST Step ST1 ST2 ST3 ST4 ST5
13 SM0 SM0 SM0 SM0 SM0 SM0 SM0
14 SCOM SCOM SCOM1 SCOM2 SCOM3 SCOM4 SCOM5
15 SM1 SM1 SM1 SM1 SM1 SM1 SM1
16 CS Chip Select CS1 CS2 CS3 CS4 CS5
17 ENA Enable ENA ENA ENA ENA ENA
18 +5V +5V +5V +5V +5V +5V +5V
19 GND GND GND GND GND GND GND
20 GND Ground GND GND GND GND GND