LED WASHER RGB IP34 F7200182
www.flash-butrym.pl
3
4
INSTALLATION
After removing the packaging, check if the device was not damaged during transport. Before connecting to
the mains, make sure that the device is securely mounted. The manufacturer is not responsible for damage
caused by unstable mounting.
Ensure proper connection to the mains and proper grounding. Make sure that the electrical parameters are
consistent with device requirements. All activities, including connecting the device to the mains must be
performed by qualified personnel.
5
CONNECTIONS
The device is equipped with the following interfaces:
1.
DMX (in/out): XLR - 3 pin
2.
Power (in/out): IEC - C14/IEC – C13
5.1
Connecting DMX signal
The connection is performed using cable with XLR-female -> XLR-Male plugs.
5.2
Voltage specification
Input Voltage
Total Power
Frequency
110~240V
30W
50/60Hz
5.3
Connecting power supply
The device must be operated by qualified personnel. Make sure that the power grid supply parameters are
consistent with device parameters and limitations are not exceeded.
CAUTION!
In the case of cable damage do not attempt to repair. Replacement or repair can be made only
on the manufacturer or by a person with appropriate permissions.
6
OPERATION MANUAL
6.1
Control panel
The control panel is equipped with LED display and 4 control buttons with the following functions:
1.
MENU
2.
DOWN
3.
UP
4.
ENTER
1
2
3
1
2
3
GROUND
DMX +
DMX -
FEMALE
XLR
MALE
XLR
