IMPORTANT!
This manual provides all the necessary information for your product to be properly and safely installed.
Please read all instructions before installation, and make sure you follow them carefully during the
installation process. Failure to follow these instructions may result in DAMAGE to the product or vehicle,
and/or SERIOUS INJURY to you and your passengers!
NOTE: Do not install and/or operate this product unless you have read and understand all the safety information and instructions contained in this
manual.
Functions and Programming
Installation Manual:
ID-4 4 Key Compact Controller
- Push the bu
tt
on for 5 second to set as momentary switch.
- Push the bu
tt
on for another 5 second to set as momentary switch.
Momentary Switch Programming
Function
To set function buttons as momentary switch
Default
All bu
tt
ons are default as ON/OFF Bu
tt
on
P1
P2
P3
P4
Wiring
Diagram Button Function Amp
Red
-
Positive
-
Black
-
Negative
-
Yellow
P1
Output 0.2A
Blue
P2
Output 0.2A
Purple
P3
Output 0.2A
White
P4
Output 0.2A
Product Code ID-4
Voltage
10-30 VDC
Output
0.2Amp per cable
IP Ra
ti
ng
IP65
Dimension
38mm X 75.8mm X 23.8mm
Op
ti
ons
- Adjustable Arm Mount
- Motorcycle Handle-Bar Clamp
Installation
Attach and secure the controller onto the panel stand. Place the device onto a
clean desired surface, where it can be easily accessible to the user. Use the
attached adhesive pad* to secure the device onto the surface. Should you
wish to remove / re-locate the controller, you may use alcohol or similar
cleaning formula to remove the left-over adhesive residue.
* The supplied adhesive pad is designed for one time use. You may replace it
with other double side adhesive tapes.
Adjustable Arm Mount
- 1 -
