www.flash-butrym.pl
8
3.3.3.
Within 5 seconds start entering the device ID (IR address) of the lamp you want to
control, for example 004 (always give all three digits of the ID). Each received digit will
be confirmed by a green blink. After entering the last digit, press the
ENTER
button. The
correct selection of the device will be confirmed by a blue blink. Devices with an ID (
IR
address
) other than those called by the remote control will not be selected (confirmation
by a red blink).
3.3.4.
Change the functions of the selected device within 20 seconds (color, macro, DMX
address, etc.).
3.3.5.
After 20 seconds from the last change of the function, the device will return to the
standby mode, in which it will not be possible to change the function. To control it select
the device again as described in sections 3.3.2 to 3.3.3.
3.3.6.
To put the device in standby mode, press the
MODE
button.
Several devices can have the same
IR address
, which allows, for example, grouping devices in complex
lighting installations and changing the functions of the entire group covered by the pilot control beam
range. At the same time you can omit the adjacent group of lamps for which the parameters are to remain
unchanged.
6.4
Master / slave
To achieve desired effects with Master/slave mode set the first device in DMX chain as Master (
MASTER
function is [ON] ). Set the following devices to
DMX mode
->
Classic 8
->
CH 001
