LED BIG-EYE KALEIDOSCOPE Moving Head 6x15W Osram F7000546
www.flash-butrym.pl
5
5.2
Fixture linking
Setting up a DMX serial data link: at first link the first light and DMX control through XLR-connection signal
cable, then connect the light in series.
You will need a serial data link to run light show of one or more fixtures using a DMX-512 controller or to
run synchronized on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all the fixtures on a serial data link determines the number of fixtures the data link can
support.
5.3
Master/Slave fixture linking
1.
Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3pin connector
of the first fixture.
2.
Connect the end of the cable coming from the first fixture which will have a (female) 3pin
connector to the input connector of the next fixture consisting of a (male) 3pin connector. Then,
proceed to connect from the output to the input of the following fixture and so on.
5.4
Voltage specification
Input Voltage
Total Power
Frequency
100~240V
100W
50/60Hz
5.5
Connecting power supply
The connection is performed using power cable (included).
The device must be operated by qualified personnel. Make sure that the power grid supply parameters are
consistent with device parameters and limitations are not exceeded.
CAUTION!
In the case of cable damage do not attempt to repair. Replacement or repair can be made only
on the manufacturer or by a person with appropriate permissions.
