www.flash-butrym.pl
Strona 3
INSTALLATION INSTRUCTIONS
a) Installing or replacing the lamps
Before replacing the lamps let the lamps cool down, because during operation, the lamps can reach
temperatures of up to 700
℃
. Wait at least 10 minutes after use before opening the housing.
During the installation of the lamp do not touch the glass bulb bare handed. Always use a cloth to
handle the lamp during insertion and removal.
Do not install lamps with a higher wattage. They generate higher temperatures than for which the
device was designed for.
For the installation, you need a 750W strobe lamp.
Procedure:
1) Unscrew the screw
2)
Carefully remove the glass pane, making sure it doesn’t get damaged
3) Remove the old lamp carefully
4) Place the new lamp
5) Close the glass pane
6) Fasten the screw
CAUTION: 1.
Do not operate this device with open cover!
2. The glass pane has to be replaced when it is damaged!
3. The lamp has to be replaced when it is damaged or deformed!
4.
Only install the lamp with the device unplugged from the mains!
b) Replacing the fuse
If the lamp burns out, chances are the internal fuse might too. Only replace the fuse with a fuse of
the same type and rating (see technical specifications at the end of this user manual).
Since the fuse for this device is an internal fuse, it should only be replaced by your agent or an
authorized dealer.
CAUTION:
Only replace the fuse with the device unplugged from the mains!
c) Mounting the device
The installation must always be secured with a secondary safety attachment, e.g. an appropriate
safety cable.
Never stand directly below the device when mounting, removing or servicing the device.
Procedure:
The stroboscope should be installed outside areas where persons may reach it, walk by or be
seated.
Overhead mounting requires extensive experience, including amongst others calculating working
load limits, installation material being used, and periodic safety inspection of all installation material
and the device. If you lack these qualifications, do not attempt the installation yourself. Improper
installation can result in bodily injury.
Before mounting make sure that the installation area can hold a minimum point load of 10 times the
device s weight.
CAUTION:
When installing the device, make sure there is no highly inflammable
material within a distance of min. 0.5m!
CLEANING AND MAINTENANCE
The following points have to be considered during the inspection:
1) All screws for installing the devices or parts of the device have to be tightly connected and must
not be corroded.
2) There must not be any deformations on the housing, glass pane, fixations and installation spots.
3) The electric power supply cables must not show any damage, material fatigue or sediments.