An emergency push-button with a red head on the frontal panel is within easy reach from the working
place (
fig. 4
).
•
ELECTRIC CONNECTION
Be sure that the voltage of the electric line is the same as the one shown by the signal on the
machine.
The electric feeding must be fixed by means of a knife switch measuring out the capacity suitable for
the power requirement of the machine, with a four-contact three-phase plug (three earth).
Connect the machine with the terminals on the panel.
Before connecting the machine, be sure that the connections have not loosened during the shipment.
The connections must be executed in conformity with the regulations in force in the country.
•
FIRST STARTING AND TESTING
6
Put the red general switch (on the right side of the panel
control) in position 1, push the green button to start and
move the joystick (on the top of the cover as fig. 5) on the
right or on the left to select the rolling direction.
Push the red emergency button to stop the machine
If the machine is not working, check the position of the red
emergency button; it must be completely lifted.
If it is not lifted, turn it round as shown by the arrows.
Check if the sensors are in their proper position, as you can
see in
fig. 3.
Even a very slight lifting of the cover is enough to stop the
machine; the immediate stop is caused by the two position
sensors placed inside the machine (
fig. 3
).
If any safety device is violated, the manufacturer will not be responsible for damages
against people or things.
L’allacciamento elettrico deve essere effettuato da personale qualificato.
Fig. 3
The electric connection must be done by qualified operators.
Fig. 4
Fig. 5
