RGB LED Lamp with Receiver
(FISHTRON WRL3)
with automatic lighting after bite
Thank you for purchasing the FISHTRON WRL3 Wireless LED Fishing Lamp.
We hope that you’ll be satisfied.
The lamp is not only designed for normal lighting, but thanks to the integrated receiver it can be switched on automatically after bite.
Up to ten devices at a time can be stored in the lamp memory. The lamp lights-up in the bite alarm’s colour not only after the bite
based on the signal sent from the bite alarm, but also based on the signal sent from the FISHTRON ALF3 fishing alarm. The lamp can
also be controlled remotely using the lamp button on the RX MULTI receiver or the WRL-KEY.
Technical data
•
Battery: Li-Ion 5000 mAh
•
Charging: 5V/700mA maximum (charging time from full discharge approximately 7 hours) via USB-C connector
•
POWER BANK function – capacity 5000 mAh
•
Light time: full brightness up to 14 hours, reduced brightness up to 70 hours
•
LED light output: up to 550 Lm
•
Number of colours: 7
•
The lamp can be paired (used) with the FISHTRON Q9-RGB TX, FISHTRON CatFish TX3, FISHTRON NEON TX3 bite
alarms, FISHTRON RX MULTI receiver, FISHTRON ALF3 alarm and WRL-KEY
•
Number of memory positions (maximum number of devices learned at one time): 10
•
Waterproof design: IP68
•
Range: up to 700 metres in open space
•
Dimensions: 245 x 41 x 41 mm
•
Weight: 260 g
Using the lamp
There are two buttons on the lamp’s sides for control.
BLUE
to turn the lamp on/off and to change the colour of the lamp.
ORANGE
to adjust brightness and enter the pairing mode.
-
Switch the lamp on
– by briefly pressing the
BLUE
button on the side of the lamp, the current charging status of the internal
battery is displayed by means of red signal LEDs (4 LEDs – 100%; 3 LEDs – 75%; 2 LEDs – 50%; 1 LED – 25%; 1 LED
flashing – 5%); the lamp can remember the last set colour and brightness before switching off, after switching on the lamp
the internal receiver automatically turns on – the lamp has the ability to display bites from paired bite alarms or can be
controlled with a key tag
-
Switch the lamp off
– by pressing and holding the
BLUE
button for 5 seconds, the high-brightness LEDs are switched off
after 1 s and only the red signal LEDs light-up; after these LEDs go out, the lamp, including the internal receiver is switched
off
-
Colour change
– after switching the lamp on briefly press the
BLUE
button, the lamp’s colour can be set in eight steps,
namely the main LEDs switched off, white, red, green, blue, orange, purple and turquoise on
-
Brightness change
– by briefly pressing the
ORANGE
button, the brightness can be adjusted in four steps: 25%, 50%, 75%
and 100%
The lamp is equipped with a timer which switches off the lamp after about 30 s after the wireless switching on of the lamp, i.e.,
after a bite or alarm. If the lamp is switched on manually, i.e., by extending it, it stays on until it is switched off manually.
