The wireless lamp is turned on/off with a longer press of the button with a bulb symbol for about 2 seconds.
The receiver must learn the lamp in the same way as bite alarms or alarm sensors do (see the lamp
instructions).
Receiver alarm function
The LED lights up, accompanied by a melody, if there’s an alarm in the relevant AL1, AL2 or AL3 position.
Then, an alarm memory is started and the LED is lit for a short time, which then flashes at approximately
2 second intervals and the receiver beeps briefly every 45 seconds. Disable the alarm memory with a brief
press (<1 second) the bulb button.
Low battery – battery replacement
The BAT LED indicates a decrease in the battery voltage. Slow flashing of the BAT LED indicates that a
battery’s life is nearing its end approx. 1 day in advance. The LED BAT flashing quickly means the range
and activity of the receiver may already be limited. If the receiver doesn’t confirm its activity or the BAT
LED flashes quickly after turning on, it’s necessary to replace the battery.
For the receiver, the battery is replaced by pulling out the battery cover in the back. Use only quality AAA
alkaline batteries.
Pairing the bite alarm and receiver kit (saving in memory)
(The basic pairing of the kit should be done by the manufacturer. Therefore, this paragraph applies to you
only if your bite alarm doesn’t communicate with the receiver or you have purchased the bite alarm in
addition to it or the bite alarm has been replaced by a service centre. Proceed in the same way if you want
to save external alarm sensors on LEDAL1-AL3 positions.)
Turn on the receiver. When turned on, press the buttons with the PLUS and MINUS symbols
simultaneously. A short sound signal is heard after a while and the red LED 1 is lit. Use the PLUS and
MINUS buttons to get to a position where you want to save a new FISHTRON Q9-RGB TX bite alarm of
an external alarm sensor.
Turning on the bite alarm will cause a short transmission (the bite alarm LED lights up, a sound signal is
heard). The receiver picks up the signal and stores it in memory. This is signalled by the selected LED
flashing on the receiver. The learning mode is automatically terminated after learning the bite alarm. If a
given position on the receiver is already taken or the same detector is stored in another position, an error
(deep tone) is reported.
Clearing the memory
If you need to erase a bite alarm from the memory, enter the learning mode again by pressing the PLUS
and MINUS buttons on the receiver simultaneously. A short sound signal is heard and the first – red – LED
is lit. Use the PLUS and MINUS buttons to select the position you want to delete. Now delete the transmitter
with a long press of the MINUS button. After a while, a deep sound signal is heard – the memory location
has been cleared.
Exit the learning mode by pressing the PLUS and MINUS buttons simultaneously, the LED goes off. The
receiver is in normal operation mode.
Verify the entire kit operation after pairing.
Should you have any problem, feel free to contact our technical support (Mon-Fri 8 -16).
Recommendation:
Even though the FISHTRON Q9-RGB TX bite alarm is designed with a long battery life, we strongly
recommend removing the batteries when the season ends and using new ones for the following
season. The same applies to other FLAJZAR fishing products.
The FISHTRON RX MULTI specifications
•
Supply voltage: 1.5V (1 AAA battery)
•
Dimensions (H x W x D): 90 x 49 x 32 mm
Содержание FISHTRON RX MULTI
Страница 4: ......
