BlueTone™ BTHF107 User Manual
.
10
1. If pairing is successful, handsfree’s Red LED is off. The Blue LED gives 3 quick blinks per 2 seconds. If your
handset shows that paring is failed and the handsfree is still in the paring mode, you need to go back to above
steps 3-5 to repeat the paring process.
2. Your handsfree will remain in the pairing mode for about 2 minutes. If paring cannot be finished within 2
minutes, the handsfree will enter into the standby mode (without Bluetooth connection in this case). You need
to turn the handsfree off and then repeat the above steps 2-5 to restart the pairing process.
2.4.2 Erase all Paired Records
This handsfree can paired with up to 8 Bluetooth equipments. When in the paring mode, press and hold button
━
for at least 3 seconds will allow you to erase all paired bluetooth device profiles stored at the handsfree. The
handsfree will then quit from the pairing mode. The Blue LED will give 1 blink per 3 seconds.
2.4.3 Connecting/Disconnecting your Handsfree with Bluetooth Equipment
When the handsfree communicates with a Bluetooth equipment with Handsfree Profile, the Bluetooth connection
between two equipments shall be established in advance. If two Bluetooth equipments have been paired recently,
you can simply reconnect them.
Connecting your Handsfree with Bluetooth Handset
：
Initiating a request from either the handsfree or the handset can set up Bluetooth connection. Detailed operations
are as follows:
1. Initiating connection request from the Handsfree: Place the handsfree close to the Bluetooth handset and then
press button
.
2. Initiating connection request from the Bluetooth handset: Place the handsfree close to the Bluetooth handset
and then follow the handset user guide to find the handsfree and send connection request.
After connecting, you will hear a connecting tone. The Blue LED gives 3 quick blinks per 2 seconds
Disconnecting your Handsfree with Bluetooth Handset:
When handsfree is currently connecting with bluetooth handset (or in the connected mode), you can disconnect
them by:
1. Pressing and holding button
for at least 3 seconds..
2. Following the handset user guide and initiating disconnection from the handset side.
After disconnecting, you will hear a disconnecting tone, and then Blue LED gives 1 blink per 3 seconds.
2.5 Call Functions
2.5.1 Basic Call Operations
Before dialing, both your handsfree and handset must be power on. And you also need to ensure your handsfree
and handset has been linked with Bluetooth connection.
Answer Call:
Press button
.
Reject Call:
Press and hold button
━
for at least 3 seconds.
