BlueTone™
BTHF080 User Manual
Note: To get the best performance, you need to wear your headset and Bluetooth phone on the same side of your
body and ensure there are no obstructions (including parts of your body) between them.
2.3 Turn On/Off Headset
Turn on the Headset:
Long press K1, you will hear 2 sharp tones, and Blue LED gives 5 quick blinks following
by 1 blink per 3 seconds. Red LED is off. This indicates the headset is power on.
Turn off the Headset:
Long press K1, you will hear 2 low tones, and Red LED gives 5 quick blinks and then turns
off. This indicates the headset is power off.
2.4 Pairing/Connecting your Headset with Bluetooth Equipment
2.4.1 Pairing your Headset with Bluetooth Handset
Before making and answering calls, you must pair your headset and phone. Paring sets up a unique relationship
between your headset and your handset. The handset will memorize the headset’s unique ID (or passkey). This
ensures that a unique and encrypted wireless link between your headset and handset will be used during calls.
Detailed operation procedures are as follows:
1. Place your headset close to your Bluetooth handset, ensure your headset is power off and your handset is power
on.
2. Press and hold K1 for at least 6 seconds until the Blue and Red LEDs flash alternatively. You will hear 2 sharp
tones to indicate that the headset has successfully entered the paring mode
3. Following your phone user guide to active Bluetooth device search on the phone side, on your phone screen
you will see a list of Bluetooth equipments found by the phone at the end of the searching process.
4. Select this Bluetooth headset ‘BTHS080’ from the list and initiate pairing following handset’s on-screen
prompts.
5. Continue to follow on-screen prompts to enter passkey “0000” and confirm to pair the headset with your
handset. Your headset ID is now stored in the handset’s memory. When Blue LED either blinks 3 times every 3
seconds (with connection) or blinks once every 3 seconds (no connection), it indicates pairing is completed.
Note
：
1. If pairing is successful, headset’s Red LED is off. The Blue LED will blinks once per 3 seconds after a few
quick flashes. If paring is failed
，
the Blue and Red LEDs alternate continuously (for about 2 minutes). You
need to go back to above steps 3-5 to repeat the paring process.
2. Your headset will remain in the pairing mode for about 2 minutes. If paring cannot be finished within 2
minutes, the headset will enter into the standby mode (without Bluetooth connection in this case). You need to
repeat the above steps 2-5 to restart the pairing process.
2.4.2 Pairing your Headset with Other Bluetooth Equipment
In addition to Bluetooth phone, your headset can also pair with other Bluetooth equipment for realizing short
distance wireless communications. Similar pairing procedures described in the previous section 2.4.1 can be used.
You can follow the user guide of the Bluetooth equipment to complete paring operations on the equipment side.
.
8
