FK Irons Spektra EdgeX, Руководство пользователя

Страница: 3 / 6

4
3
2
1
CHANGING THE STROKE
The stroke of the Spektra Edge is adjustable to 2.8mm, 3.5mm, and 4.25mm lengths with the ability to fine tune
in between.
With the motor housing removed from the machine body, gently use your finger to turn the inner bearing of the
machine from the bottom of the machine body so that the set screw (2) of the stroke bearing aligns with the
cutout on the back of the machine (1).
Use the included 0.05” hex screwdriver to gently loosen the set screw in order to lock the screw in the machine
cutout (1) to prevent the turning of the bearing. Be careful to not fully remove the set screw.
Loosen screw half way out then adjust the stroke of the machine by carefully sliding the stroke bearing (4) to the
left and right inside the slot of the stroke plate (3) under the machine slider using the hex screwdriver. Positioning
the “Edge” engraving of the machine facing you, with the bearing aligned all the way to the left of the machine
(indicated by 1 engraved dot), the machine will have a 2.8mm stroke, centered evenly it will have a 3.5mm stroke,
and aligned all the way to the right the machine (indicated by 2 engraved dots) will have a 4.25mm stroke.
You are also able to select a number of options between the main settings as well to select the stroke that best
suits the style you are looking to achieve. After the desired stroke is selected, use the screwdriver to re- secure
the set screw completely. It is recommended to push inward with the tool while tightening to prevent stripping the
locking screw and use a paper towel around the screwdriver handle to ensure enough torque is applied to fully
lock the screw.