Read the ENTIRE IMPORTANT SAFETY WARNINGS AND PRECAUTIONS section at the beginning of this
manual before set up or use of this product.
Display Features
Voltage Switch
Switch to 6v or 12v for the battery type that is to be charged.
LED Display of Charging
The red LED indicates the battery is being charged. And will not indicate when the battery is fully charged,
reverse polarity, short circuit or is in the float stage.
CAUTION: TO PREVENT BATTERY DAMAGE: DO NOT USE on gel batteries or
AGM (absorbed glass mat) type batteries.
Charging Procedure
1. Check Battery Charger/Maintainer and Battery Status
2. Place the Battery Charger/Maintainer on a stable, flat surface. Then check for cracked or broken parts,
damaged power cords, clamps, and any other condition that may affect the safe operation of the Battery
Maintainer.
Connecting the Battery Charger/Maintainer to your Battery
3. Make sure the area where battery is being charged is well ventilated.
4.
Place the Battery Charger/Maintainer on a stable, flat surface as far from the battery as possible.
5.
DO NOT PLACE the battery Charger/Maintainer on top of the battery.
6.
Connect the Red Charging Clamp to the positive (+) terminal of the battery. Connect the Black Charging
Clamp to the negative (-) terminal or appropriate ground
. Do not connect black charging clamp to
fuel lines or carburetor.
7. If the battery charger/maintainer is connected correctly the red LED light will be lighted.
Connect the Battery Charger/Maintainer to the Power Supply (120V AC)
1. Plug the Input Power Cord into 120V AC power supply, The red LED Charging Indicator light will remain
lighted during the battery charging stage.