FiveStar 401TR, Руководство владельца/оператора, Страница: 5 / 20

TO CLEAN UPHOLSTERY:
Cleaning upholstery with success requires a good knowl-
edge of the type of fabric to be worked on. Look for the
cleaning label sewn on the underside of the furniture
for the recommended method of cleaning the fabric. If
it calls for dry cleaning, do not attempt to clean with the
wet extraction method. Otherwise, damage to the fabric
could occur. Extraction works on most synthetic fibers.
Before proceeding, test fabric for colorfastness. Pour a
small amount of cleaning solution on the fabric in an in-
comspicious spot. Rub the area with a white terry towel.
If no color comes off the towel, the fabric should be safe
to clean. If color transfers, do not continue.
1.
PREPARE THE MACHINE
Complete Step 1 under Carpet Cleaning Instructions us-
ing approved Upholstery Cleaning Solution. Disconnect
the vacuum hose with black hose cuff from the lidand
disconnect the solution hose from the back of the ma-
chine. Replace them with the upholstery hoses.
2. TO CLEAN
For 401TR models, turn switch to upholstery position.
Turn pump switch “ON.” Depress upholstery tool trigger
while pulling tool across upholstery surface with over-
lapping strokes. To speed drying go over the upholstery
without depressing the trigger. Continue cleaning until
cleaning solution is consumed. Empty and rinse bucket.
Repeat Step I and 2.
For 411TR models, turn the solution control valve
located on the side of the machine to “CARPET.” Turn
the black rocker switch to the “UPHOLSTERY” position.
Turn the Vacuum switch to the “ON” position. Depress
upholstery tool trigger while pulling tool across uphol-
stery surface with overlapping strokes. To speed drying
go over the upholstery without depressing the trigger.
Continue cleaning until cleaning solution is consumed.
Empty and rinse bucket. Repeat Step I and 2.
3. CHECK BUCKET LID
See Step 3 under “To Clean Carpet.”
4. CLEAN MACHINE BEFORE RETURNING
See Step 4 under “To Clean Carpet.”
TO CLEAN HARD FLOORS (411TR ONLY)
If your machine is a 411TR, it has a solution control
valve located on the side of the machine, you may clean
hard floors using the following instructions.
WARNING:
USE ONLY APPROVED FLOOR CLEANING
SOLUTIONS.
WARNING:
T
o avoid possible scratching on soft surfaces
such as marble, vinyl, etc., remove all abrasive
materials from the surface to be cleared, such
as sand, etc.
The FiveStar is intended to be used to scrub
and clean hard floors surfaces.
• DO NOT use the machine to apply finish.
• DO NOT use the machine to apply stripper.
• DO NOT use the machine to vacuum up
stripper
1. PREPARING THE MACHINE:
Complete Step 1 under Carpet Cleaning Instructions
using approved Upholstery Cleaning Solution. Dis-
connect the vacuum hose with black hose cuff from
the lidand disconnect the solution hose from the
back of the machine. Replace them with the uphol-
stery hoses.
1. TO CLEAN:
Turn the solution control valve located on the side
of the machine to “FLOOR” then follow the 411TR
sections of 2,3, and 4 under “TO CLEAN CARPET”
5