FITFIU FITNESS 1100037, Инструкция по эксплуатации

Страница: 43 / 58

43
BESP-200
EN
MAINTENANCE
Care has been taken to assure that your bike has been properly adjusted and lubricated at the factory. It is not
recommended that the user attempt service on the internal components instead seek service from an authorized
service center. However, from time-to-time the outer surfaces may appear dull or dirty, following the instructions listed
below will restore and preserve the original finish.
• The bike can be cleaned with a damp cloth and a mild non-abrasive detergent. Do not use solvents, sprays,
aerosols or pumps because they will leave wax residues on the surface of the screen.
• From time to time, the surface of the screen will have finger marks or dust on it. The use of harsh chemicals will
damage your protective coating and create static energy that will damage the components. This surface should
be cleaned with special chemicals that are sold in computer shops and which are special for anti-static surfaces.
We recommend the use of these products.
• The safety of the equipment is maintained if its condition, damage and wear are regularly checked.
•
The bicycle must be moved and moved carefully to avoid injury.
• The brake part is the one that wears out most easily. Before using the bicycle, check that the brake system is
working properly.
• Lubricate the moving parts with soft oil periodically to prevent premature wear.
•
Check that the fastening elements are tightened properly.
• Carefully inspect the parts most susceptible to wear.
•
Replace defective parts immediately.
• Keep the appliance out of service until it is repaired.
•
Please check that all safety labels are in good condition and can be read. If any are missing or damaged, contact
your dealer to order new ones.
TROUBLESHOOTING
The following information may assist in identifying a problem and rectifying it.
Problem Cause Solution
The display does not show
any information
Badly connected or broken signal
cable
Check that the cable is connected correctly
The batteries are exhausted Change the batteries
The display shows 0 and
not other numbers while
pedalling
You have selected the pulse mode Place your hand on the heart rate monitor
The sensor cable is broken Change the sensor cable
The unit is unstable or
moves while in use
The unit is not on a solid, level
surface Place the unit on a stable surface or adjust
the level of the bicycle
The exercise bike produces
a squeal
The unit is not on a solid, level
surface
Place the machine on a level surface
Ungreased equipment
Loosen all mounting parts, grease the bolt
threads and tighten the parts
NOTE: If, after having checked the settings and the device, you cannot use the product, call the
FITFIU Technical Service.