6 Operating Instruction
1) Connect to a power source with appropriate wiring (DC/DC converter only) and press power switch.
The Indication Lamp (LED) lights red to indicate power is being supplied to the S218R-200.
2) The LED color will change from red to green approximately 15 seconds later to indicate that the
S218R-200 is warmed up and ready to use.
3) Hold the fiber with a fiber holder, with approximately 30mm (25
– 35mm) of fiber end protruding from
the holder. Open the Holder clamp lid and the Heater lid, and place the fiber holder firmly in the Holder
clamp.
4) Ensure that the fiber rests in the heating area and
the fiber end is within Min. and Max. line of the
Heater. Refer to the drawing.
5)
Close the Heater’s lid first, and then the Holder clamp lid.
6) Firmly grasp the Heater
lid and the Holder clamp’s lid, and wait until flashing of the indication LED
stops. Then, pull the holder clamp away from the Heater slowly.
7) Open the Holder clamp lid and the Heater lid and remove the fiber holder.
8) Remove coating material refuse from the Heater and clean the heating area.
CAUTION : Do not touch the Heater.
9) When finishing to working of S218R-200, press power switch again.
If not used the S218R-200 will auto power off after 10 minutes. (Auto Power OFF)
Make sure that both sides overlap
Set the fiber on the heater
This part is not a blade.
Make sure the fiber is not riding
on this part.
