F7000N Tip Alignment Device Guide
Rev. A – May 20
th
2015
Fisnar Inc. | 19C Chapin Rd. Ste. 307, Pine Brook, NJ 07058 | T: (973) 646-5044 | [email protected] |
www.fisnar.com
- Page 8 -
v.
Device Movement
As the tip moves, it is triggering the sensors and its position is being recorded. If the Tip Alignment fails,
make sure the tip is triggering the sensor as it moves in the X, Y and Z direction. This can be easily done
by adjusting the starting position of the tip in the Tip Search Position command as well as the Length it is
searching in the Z direction.
The above images show the movements and positions the Tip Alignment Device makes when it is
correcting for offsets. Home Position, Tip Starting Position and the Tip Search Pattern are all shown
above.
vi.
Tip Changing Examples
1). Program 0 and program 1 are using an 18 Gauge tip with the same Setup Position.
If the tip is changed to another 18 Gauge tip,
To use program 0 => load program 0 =>run XYZ Search.
To use program 1 => load program 1 =>run XYZ Search.
Home Position
Tip Starting Position
Tip Search Pattern
