A
Turn unit on.
B
Turn amber light on – this will provide continuous flow of
material as long as the foot pedal is depressed.
C
Turning the pressure adjust knob (
D
) allows for
adjustments of air pressure.
E
Push foot pedal to start dispensing.
The amount of liquid dispensed depends on air pressure, size of
dispense tip, viscosity of material and time of pulse (
F
).
To produce timed deposits, press (
B
) to turn off amber light.
C D F A B G
1.
Hold the barrel at approximately 60º (
±
20º) angle (Fig. 1).
2.
After making deposit remove tip as shown (Fig. 2).
3.
Do not permit the liquid to flow back into the controller as shown in Fig. 3.
HELPFUL HINTS FOR MAKING DEPOSITS
4.
Increase or decrease size of dots by either:
Increasing or decreasing time only (
F
)
Increasing or decreasing pressure only (
C
) (
D
)
Increasing or decreasing size of tip
Increasing or decreasing any combination of time, pressure and size of tip.
5.
To increase pressure, turn knob (
D
) clockwise. To decrease pressure, first
turn knob (
D
) counter clockwise past the value desired and then clockwise to
the value desired.
6.
For thin liquids, like water, you can prevent dripping by slowing turning the
vacuum control (
G
) counter clockwise. WARNING – Too much vacuum
will cause bubbles and suck liquid back into the controller thus creating
permanent damage to the unit.
FIG. 1
FIG. 2
FIG. 3
60º
UNDERSTANDING THE FUNCTIONS
OF YOUR DISPENSER DISPLAY
- 3 -
E
