9
9
I n s t a l l a t i o n G u i d e
I n s t a l l a t i o n G u i d e
Fasten the Jack in the Endpin Hole
Follow this sequence when installing the endpin jack:
1 - Shielding Cap
2 - First Large Hex Nut
3 - Large Dress Washer
4 - Star Washer
5 - Guitar Endblock
6 - Small Dress Washer
7 - Small Dress Nut
8 - Strap Button
The jack should protrude at least 5/16" and no more than 11/32" outside of the guitar body for
proper fit. After fitting the small dress washer and nut over the end of the jack, insert the 3/32"
allen wrench through the small hole on the end of the jack. Tighten the nut with the 1/2" open end
wrench while holding the jack in place with the allen wrench. Thread and hand tighten the strap
button.
NOTE: With the strap button in place, the end of the jack
should protrude slightly, so that when a plug is inserted, it
will snap securely in place.
I
NSTALLING THE
M
ODEL
SBT-HP
The Model SBT-HP is designed for harp or piano.
PARTS
•
SBT-HP with 42" Cord and 1/4" Jack
•
(3) Double-sided Adhesive Pads
•
Adhesive-backed Jack Holder
As a general rule, the transducer should be mounted over a freely vibrating location and not over
a "dead" structural brace. The exact location for best results should be determined by experimen-
tation.
3 4
5
6
7
8
2
1
