3
Setup
Leave the strings on and loosen the pickup clamps with a Phillips screwdriver.
Position the pickup in the soundhole, parallel to and as close to the end of the
fi ngerboard as possible. Gently tighten the clamps until snug and run the cable
out the soundhole. Take care not to over-tighten the clamps or you may perfo-
rate the fi nish.
Travel / Storage
Remove the pickup during travel or if you store the guitar for long periods. If the
pickup becomes dislodged inside the instrument during travel, it could damage
the guitar. If the rubber cable comes to rest on the guitar’s fi nish while the instru-
ment is stored, it may interact with the lacquer and leave a permanent mark.