- 4 -
Preamp Installation continued…
Thread and gently tighten the strap button using
rubber tipped pliers.
Note:
With the strap button in place, the end of the
jack should protrude slightly, so that when a plug is
inserted, it will snap securely in place.
VOLUME & TONE MODULE and BLEND
MODULE
(Mic Blend only)
The Infinity VT and Infinity Mic Blend come ready to install
into a steel string instrument. For steel string instruments,
move to the next step:
Control Module Install
.
For Control Module Installation in a Nylon String Guitar see:
Classical Style Control Modules
on page 7
Control module Installation
Control Module locations:
Test the area where you will mount the Volume & Tone
control module. Remove any lacquer and/or buffing
compound from this area using fine grit sandpaper. Clean this
surface with an alcohol wipe or a cotton swab moistened
with rubbing alcohol. Let dry.
Note:
For the strongest bond we recommend a water-based
primer/sealer be applied to the bare wood inside the
soundhole. A light film of yellow wood glue spread by
fingertip works well for this application. Let the primer/ sealer
dry before continuing.
