Digital Drybath
Important Notes | 3
Regulatory Compliance
European Union
Product Safety
This product family has been tested to applicable product
safety standards by a Nationally Recognized Test Laboratory
(NRTL) and may bear the NRTL’s mark of safety compliance
to those applicable standards.
The openings on this instrument are for ventilation
circulation and in order to avoid over-heat of the
instrument body they should not be blocked or covered.
When a single set of instrument is used, the interval
between ventilation opening before and after the
instrument and its nearest object should not be less than
25 cm. Also, don’t use the instrument on loose or soft
surface, or the air inlet of instrument bottom might be
blocked.
Excessive temperature will impair performance or result
in failure of the instrument. This instrument should not be
used in locations subjected to direct sun light.
The instrument should be kept away from hot gas, oven
and all other heat sources. If the instrument is to be
stored for a long time, the power plug should be
withdrawn and the instrument covered with soft cloth or
plastic film to avoid entrance of dust. The product is
powered by connecting the mains plug to a standard
socket-outlet. Always place the product in such a way
that it is easy for the operator to disconnect the product
from the mains supply.
•
Explanation of symbols
Attention, read user manual before use.
WARNING:
There is a sign of
"CAUTION: HOT SURFACE! or
ATTENTION: SURFACE HOT" on the
instrument. The metal part (module)
near the sign should not be touched
with any part of the body when the
Instrument is operating in a high
temperature state or just finished
operation to avoid burns!
Alternating Current
Protective Conductor Terminal
CAUTION:
In any of the following cases,
immediately cut off the power supply, withdraw
the power plug from the power socket and
contact the supplier for service:
•
Liquid drops into the inside of the
instrument.
•
The instrument is rained on or water is
spilled on it.
•
The instrument works abnormally,
especially when generating an abnormal
sound orodor.
•
The instrument is dropped or its casing is
damaged.
•
The function of instrument obviously
changes.
The European voltage models of this product
meet all the applicable requirements of the
European Directives and therefore display the CE
Marking. These Directives are captured in the EU
Declaration of Conformity which may be obtained
from the manufacturer.
CEEMC
EN 61326-1
CE Safety
EN 61010-1 CE
Safety
EN 61010-2-010
UL
61010-1/CSAC22.2 NO.61010-1
ROHS2.0
2011/65/EU
