Fisher M-Scope COIN STRIKE, Руководство по эксплуатации

Страница: 12 / 28

10
QUICK START GUIDE
We strongly encourage you to thoroughly read and understand
everything in this operation manual prior to using your new
Fisher Coin Strike. This will enable you to obtain the optimum
performance when you detect. However, we can provide a few
quick suggestions that can help you get started. To begin hunting
with your new Coin Strike, you will at least need to be familiar with
the control panel (see page 6).
1. Turn ON the Coin Strike by pressing and releasing the POWER
button.
2. Push and release the MENU button. Push this button
repeatedly until the MEM icon flashes. Then, press the UP
arrow button until the two-digit display shows “FP” (factory
preset). Finally, push and release the P/P (MEM) button. This
will set the Coin Strike as follows:
Iron Disc = 99
Threshold = 0
Sensitivity = 7
Salt Mode OFF
Volume = 10
Notch Disc: Eliminate Foil and Tabs
These factory present settings are a good start for COINS
only hunting.
3. Lower the search coil to the ground in an area completely
void of metal. Next, press the AUTO GROUND button and
hold it for about 2 seconds. Then, while still holding the AUTO
GROUND button down, lift the coil about 6 inches off the
ground, hold for a second, and release the button. The
Coin Strike will give you a brief tone to let you know the
ground balance has been achieved.
4. Begin your search, using the method described on
page 19.
5. If you prefer to hunt using our advanced FisherTrack system,
or other advanced features (such as the salt mode), please
refer to this operation manual.