Lit. No. 43115, Rev. 00
2
June 1, 2013
43119
Leveling Adjustment Procedure
1. With the snowplow attached to a properly ballasted
vehicle and the blade lowered to the ground, the
T-frame should be parallel with the ground.
If the T-frame is parallel with the ground,
go to
Step 4.
If the T-frame is not already parallel with the
ground,
place the snowplow in the scoop position
and follow Steps 2–4.
2. Loosen the front fasteners connecting the
pushbeam to the T-frame, but do not remove them.
Next, remove the rear fasteners connecting the
pushbeam to the T-frame. Level the T-frame so its
parallel with the ground.
3. Select the hole in the rear of the T-frame that is
aligned closest to the rear holes in the pushbeam.
Reassemble the previously removed fasteners into
the rear holes.
4. Lubricate and tighten all fasteners to 250 ft-lb.
Select the hole best
aligned with rear holes
in push assembly
Front
Fasteners
Rear Fasteners
T-Frame
Push
Beam
Fisher Engineering reserves the right under its product improvement policy to change construction or design details and furnish equipment
when so altered without reference to illustrations or specifi cations used. Fisher Engineering or the vehicle manufacturer may require or
recommend optional equipment for snow removal. Do not exceed vehicle ratings with a snowplow. Fisher Engineering offers a limited
warranty for all snowplows and accessories. See separately printed page for this important information. The following are registered (
®
) or
unregistered (™) trademarks of Douglas Dynamics, LLC: FISHER
®
.
Printed in U.S.A.
