INSTALLATION INSTRUCTIONS
Pushbeam Installation
1. Park the vehicle on a smooth, level, hard surface,
such as concrete. Lower the blade to the ground,
and turn the control to the "OFF" position.
Disconnect the snowplow from the vehicle, or
turn the vehicle ignition to the "OFF" position and
remove the key.
2. Align the front holes in the pushbeam with the
front holes in the T-frame. Loosely fasten with two
3/4" x 2-1/2" carriage bolts* and 3/4" locknuts.
T-Frame Service Kit
A DIVISION OF FISHER, LLC
Fisher Engineering
June 1, 2013
Lit. No. 43115, Rev. 00
50 Gordon Drive, Rockland, Maine 04841-2139 • www.fi sherplows.com
CAUTION
Use standard methods and practices
when attaching snowplow and installing
accessories, including proper personal
protective safety equipment.
CAUTION
Read this document before installing the
T-Frame Service Kit.
WARNING
Do not exceed GVWR or GAWR, including
blade and ballast. The rating label is found on
the driver-side vehicle door cornerpost.
3. Align the rear holes in the pushbeam with the rear
holes in the T-Frame and fasten in the middle
position using two 3/4" x 2-1/2" carriage bolts* and
3/4" locknuts. Tighten until assembly is secure, but
do not torque at this time.
4. Assemble the rest of the snowplow.
5. Check that the T-frame is parallel with the ground
as described in Step 1 under "Leveling Adjustment
Procedure."
3/4" Locknut
3/4" x 2-1/2" Carriage Bolt*
3/4" Locknut
3/4" x 2-1/2" Carriage Bolt*
* 3/4-10 x 2-1/2 Hex Cap Screws (PN 90459) are required
when attaching the T-frame to a push assembly with round
holes instead of square holes.
43119
