8
8
Assembly
Countertop
Refrigerator
Openings
Sink
Opening
• Position the countertop so that the sink opening is
above the refrigerator openings. Fit the countertop
to the assembly.
9
9
• Insert ten screws up through the front, back and side
panels and into the countertop. Tighten the screws
with a Phillips screwdriver. Do not over-tighten.
Hint:
You may find it easier if you tip the assembly
first backward and then forward to tighten the screws.
Side Table
Support
Side Table
Groove
Peg
• Place the side table down on a flat surface.
• Fit the grooves in side table support onto the pegs
on the side table.
• Insert two screws into the pegs in the side table.
Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
11
11
Side Table
Assembly
Base
Extension
• Position the side table assembly at an angle, as shown.
• Insert and
“snap”
the tabs on the bottom of the side
table assembly into the slots in the base extension.
• Insert and
“snap”
the remaining tabs on the side table
assembly into the slots in the side panel.
Groove
Peg
5
10
10
