BATTERY CHARGING AND INSTALLATION
• Plug the 9.6V NiMH battery connector into the charger connector.
• Plug the charger into a standard wall outlet. The charger L.E.D. turns red.
Notes:
If power fl ow to the wall outlet is controlled by a switch, make sure the switch is “ON”.
Use the charger only in a wall outlet. Do not plug the charger into a ceiling outlet. To connect to
a supply that is not in the United States, use an adapter (not included and sold separately) with
the proper confi guration for the power outlet.
• Charge the battery for
four hours
. When charging is complete, the charger L.E.D. turns green.
• Disconnect the charger connector from the battery connector. Unplug the charger from the
wall outlet.
Charger Connector
9.6V NiMH
Battery Connector
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn
injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely. Do not dispose of this product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
• Protect the environment by not disposing of this product with household waste
(2002/96/EC). Check your local authority for recycling advice and facilities.
Remote Control
• Locate the battery compartment door on the bottom of the remote.
• Loosen the screw in the battery compartment door with a Phillips screwdriver. Remove the
battery compartment door.
• Insert three “AA” (LR6)
alkaline
batteries.
Hint:
We recommend using
alkaline
batteries for longer battery life.
• Replace the battery compartment door and tighten the screw with a Phillips screwdriver.
1.5V x 3
"AA" (LR6)
Dinosaur
• Locate the battery compartment on the bottom of the dinosaur.
• Loosen the screw in the battery compartment door with a Phillips screwdriver. Remove the
battery compartment door.
• Plug the 9.6V NiMH battery connector into the dinosaur connector.
•
Fit the connectors into the back slot in the battery compartment and then place the 9.6V
NiMH battery pack on top.
• Replace the battery compartment door and tighten the screw with a Phillips screwdriver.
ICES-003
• This Class B digital apparatus complies with Canadian ICES-003.
• Operation is subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including interference
that may cause undesired operation.
NMB-003
• Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
• L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes :
(1) il ne doit pas produire de brouillage et (2) l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible
de compromettre le fonctionnement du dispositif.
