4
11
• Place the loops at the top of the net into the grooves on the ring.
• Pull each loop through a ring tab, as shown.
Hole
Hole
Rectangular Tabs
Hole
Rim
Hole
Net Assembly
• Place the rim on a flat surface with the rectangular tabs facing up.
• Locate the four screw holes on the underside of the net assembly.
• Align the four screw holes on the underside of the net assembly with the
four holes in the rim.
• Place the net assembly onto the rim.
• While holding the ring assembly and rim together, turn them over.
• Insert four screws into the holes in the rim, making sure each hole in the
rim is still aligned with each screw hole in the net assembly.
• Partially tighten the screws with a Phillips screwdriver. Turn the rim
over to ensure that the net loops are still in the grooves and through the
ring tabs before completely tightening the screws. Do not over-tighten
the screws.
Rim
Groove
Ring
Tab
Groove
Ring
Ring Tab
Side Edg
e
Side Edg
e
3
2
4
5
1
Proper label application will help to keep the label looking its best!
• Make sure the area where the label will be applied is clean and dry. Wipe
the backboard with a clean, soft, dry cloth to remove any dust or oils.
• For best results, avoid applying the label more than once.
• Peel the backing from one half of the label. Do not remove all of the backing!
• Align the side edge of label
1
(where backing is removed) with the side edge
of the label area on the backboard.
• Carefully apply the side edge of the label to the side edge of the label area
on the backboard.
• While rubbing the label in place, continue to peel the backing from the
other half of the label.
• Apply the remaining labels to the backboard. Labels
2
-
5
are designed
to overlap.
• Dispose of the label backing properly.
ASSEMBLY
ASSEMBLY
ASSEMBLY
2
3
4
