136
SYMPTOM
SOLUTION
The ball has gone through the
chute target, but the scoreboard
didn’t recognize it.
The golf ball rolls into the
golf cup but the scoreboard
didn’t recognize it.
Chute/Basketballs/Footballs/
Baseballs have a lot of static.
I cannot lift the nets for storage.
I hear a popping noise when
I lift the nets.
• You probably forgot to press the START button. Press the button
and begin play!
• The scoring mechanism is sensitive to lighting conditions. Do not
use the GameStation
TM
in areas of direct sunlight. Do not use
outdoors or in front of a window.
• Battery power is weak or batteries are dead. Replace all four
batteries with fresh, "C"
alkaline
batteries.
• The white wires are not properly connected. Turn the power off.
Locate the ON/OFF switch on the back of the game selector. Slide
it OFF. Open the connector cover by removing the two screws with
a Phillips screwdriver. Look for the white wires. Disconnect the
white wires. Look inside the connector at the pins. Make sure the
pins are not bent. Reconnect the white wires. Replace the connector
cover and turn power back on. Locate the ON/OFF switch on the
back of the game selector. Slide it ON. To play, be sure to select a
game, then a sport and finally press START.
• You will need to reset the electronics. Locate the ON/OFF switch
on the back of the game selector. Slide it OFF and then back ON
again. To play, be sure to select a game, then a sport and finally
press START.
• You probably forgot to press the START button. Press the button
and begin play!
• Battery power is weak or batteries are dead. Replace all four
batteries with fresh, "C"
alkaline
batteries.
• The golf ball must roll over the switch in the golf cup. Make sure the
switch is not covered.
• The red wires are not properly connected. Turn the power off.
Locate the ON/OFF switch on the back of the game selector. Slide
it OFF. Open the connector cover by removing the two screws with
a Phillips screwdriver. Look for the red wires. Disconnect the red
wires. Look inside the connector at the pins. Make sure the pins are
not bent. Reconnect the red wires. Replace the connector cover and
turn power back on. Locate the ON/OFF switch on the back of the
game selector. Slide it ON. To play, be sure to select a game, then
a sport and finally press START.
• You will need to reset the electronics. Locate the ON/OFF switch
on the back of the game selector. Slide it OFF and then back ON
again. To play, be sure to select a game, then a sport and finally
press START.
• Rub the chute/Basketballs/Footballs/Baseballs with a fabric softener
dryer sheet.
• You must first pull the nets out (to remove from the lower net clips)
and then lift the nets.
• The net pivots were designed this way and the sound is normal.
Содержание GAMESTATION C4492
