M9779b-0920
14
BACK VIEW
• Insert the "T" fastener end of a short seat belt strap through
the slot near the outer edge of the seat. Make sure the
fastener side of the seat belt faces inward.
Note:
You will pull only one T-Loop through the slot.
• Repeat this procedure to assemble the other short seat
belt strap.
• Insert each fastener end of the long seat belt strap through
the slots in the center of the seat. Make sure the fasteners
face the outer edge of the seat.
• Pull each side of the long seat belt strap evenly through
the slots. Make sure to pull each T-loop through a slot.
• Turn the vehicle upright.
• Insert both tabs on the back edge of the seat into the slots
inside the bed.
22
Short Seat Belts
Long Seat Belt
• Insert two screws through the back of the seat and into
the vehicle. Tighten the screws.
24
23
Slots
Seat
• Align the tabs on a hubcap with the slots in a rear wheel.
“Snap”
a hubcap into the center of the rear wheel.
Hint:
If the hubcap does not
"snap"
into place, you may not
have assembled the wire clip properly. Remove the wire clip
and refer back to step 18.
• Repeat steps 17 - 21 to assemble the other rear wheel, wire
clip and hubcap.
21
Hubcap
Screws
