• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to attach the other ends of the frame
tubes to the frame on the other side of the base.
• Position the base wires around the base so that the ends point
upward and are against the
lower
holes in a frame.
• Place a spring onto an M6 x 1
5
/
8
” screw.
• Insert the M6 x 1
5
/
8
" screw with spring through a base wire and
into the frame.
• Fit an M6 lock nut (so that the protruding side is toward the
fabric) into each
lower
hexagonal opening on the back of
the frame.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to attach the other ends of the base
wires to the frame on the other side of the base.
Base Wire
Lower Hole
Spring
Frame
• Position one end of the metal canopy stay against the
upper
hole in a frame.
• Insert an M5 x 1
13
/
16
" screw through the hole in the cover.
• Fit the end of the screw through the hole in the metal canopy
stay and into the
upper
hole in the frame.
• Push on the cover to insert and “snap” the tab on the cover into
the slot in the frame.
Make sure you hear a “snap”.
• Fit an M5 lock nut (so that the protruding side is toward the
fabric) into the
upper
hexagonal opening on the back of
the frame.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to attach the other end of the metal
canopy stay and the remaining cover to the frame on the other
side of the base.
Upper
Hole
Cover
Slot
Tab
Lower Hole
M5 x 1
13
/
16
" Screw -2
Metal Canopy Stay
M6 x 1
5
/
8
" Screw - 4
M5 Lock Nut -2
Protruding
Side
Protruding Side
M6 Lock Nut - 4
5
5
ASSEMBLY
6
7
Spring - 4
