Fisher Engineering STEEL-CASTER 99000-1, Руководство по установке

Страница: 10 / 16

Lit. No. 43765/43767, Rev. 02 10 August 1, 2018
MOUNTING THE SPREADER
Install Chute to Spreader
Before installing the chute to the hopper, con fi rm that
the spinner turns freely. If it does not, refer to "Spinner
Belt Alignment" in the Final Adjustments section of
these instructions.
1. Pick up the chute from each side and slide the
chute-side hinges over the hopper-side hinges.
Two people are recommended for this step.
2. Line up the hinge pivot holes. Insert a
1/2" x 8-1/4" chute pin on each side and secure
with a 3/32" x 2-1/4" cotter pin.
3. Connect the chute motor plug to the hopper
harness plug.
The chute can pivot on either pin to provide access to
the feed area of the hopper. An interlock prevents the
feed system from running when the chute is rotated to
either side or removed.
Hinge
Pivot Holes
Chute
(Pivot)
Pins
INSTALL TIE-DOWN STRAPS
Install tie-down straps from the tie-down loops on the
spreader body to the truck frame. Use one strap per
loop, pulling diagonally away from the hopper body.