Lit. No. 26244, Rev. 06
2
March 15, 2010
26239 – Stainless, 26240 – Black
Copyright © 2010 Douglas Dynamics, L.L.C. All rights reserved. This material may not be reproduced or copied, in whole or in part, in any
printed, mechanical, electronic,
fi
lm or other distribution and storage media, without the written consent of Fisher Engineering. Authorization
to photocopy items for internal or personal use by Fisher Engineering outlets or snowplow owner is granted.
Fisher Engineering reserves the right under its product improvement policy to change construction or design details and furnish equipment
when so altered without reference to illustrations or speci
fi
cations used. Fisher Engineering or the vehicle manufacturer may require or
recommend optional equipment for snow removal. Do not exceed vehicle ratings with a snowplow. Fisher Engineering offers a limited
warranty for all snowplows and accessories. See separately printed page for this important information. The following are registered (
®
) or
unregistered (™) trademarks of Douglas Dynamics, L.L.C.: FISHER
®
, ProTube™.
Printed in U.S.A.
INSTALLATION INSTRUCTIONS
1. Place the driver-side mounting bracket into the
driver-side connecting arm as shown.
2. Put a 1/2"
fl
at washer onto a 1/2" x 4" cap screw,
then insert the cap screw through the holes in the
driver-side mounting bracket and the connecting
arm. Put another 1/2"
fl
at washer over the end of
the cap screw. Place a 1/2" locknut on the cap
screw and hand tighten. Leave the 1/2" fasteners
loose enough to allow for future adjustment.
Repeat for the passenger's side.
NOTE: The center-to-center measurement
for the snowplow connecting arms should be
approximately 29-1/8". If the distance is less than
that, you may have to insert 1/2"
fl
at washers to
eliminate the gap between the connecting arms
and the ProTube™ brackets.
3. Position a clamp against the side of the driver-side
mounting bracket. Put a 3/8"
fl
at washer on two
3/8" x 1-1/4" cap screws. Insert the two cap
screws with washers through the holes in the
clamp and the driver-side mounting bracket. Put
another 3/8"
fl
at washer over the end of each cap
screw. Place 3/8" locknuts on the cap screws
and hand tighten. Leave the 3/8" fasteners loose
enough to allow for future adjustment. Repeat for
the passenger's side.
4. Install the ProTube bumper/grille guard into the
driver- and passenger-side clamps, and adjust the
position as desired. Tighten all fasteners.
NOTE: After
fi
ve to ten hours of usage, retorque
all ProTube fasteners.
Mounting
Bracket
Connecting
Arm
1/2" Flat Washers
(If required, see note below.)
