Too much detergent
used.
Ensure the correct dose of detergent is used for the load
size and soil level (refer to '
Detergent & Frabric Softener'
).
Not spinning properly
Load has gone out of
balance.
Open door and redistribute load, then restart the washer.
Machine is not level.
Ensure machine is correctly levelled (refer to
'Installation
Instructions - Levelling the Machine'
).
Suds build up.
Check the amount of detergent used, reduce if necessary.
Too many soap suds
Incorrect type of
detergent used.
Use low sudsing, front loader detergent only (refer to
'
Detergent & Frabric Softener'
).
Too much detergent
used.
Ensure the correct dose of detergent is used for the load
size and soil level (refer to '
Detergent & Frabric Softener'
).
Small puddle of water
from under the
machine
Inlet hose or drain hose
leaking.
Check inlet hoses and the drain hose are correctly attached
and not damaged.
Lots of suds.
Suds may have leaked and then dissolved.
Detergent dispenser
blocked.
Clean detergent dispenser drawer (refer to '
Caring for your
Washer'
).
Detergent dispenser
drawer not fully closed.
Close detergent dispenser drawer fully and ensure it
remains closed during the cycle.
Damage to door seal.
Check seal inside door for damage. If it sustains any
damage it will need to be replaced.
Cycle time longer than
usual/Inaccurate time
reading/ Adjustment of time
remaining during cycle
Wash time is
approximate.
Wash time may be influenced by a number of factors
(refer to
'Washer Controls'
).
Low water pressure or
flow rate.
Ensure that inlet hose filters are not blocked.
Out of balance or
oversudsing.
Recovery from out of balance or oversudsing will extend
cycle time (refer to
'Before you call for Service'
).
Washing a large load.
Be aware that it will take longer for the machine to fill.
Selecting various
options.
Be aware that some options will extend cycle time.
Detergent or fabric softener
remaining in detergent
dispenser at the end of the
cycle
Detergent drawer not
properly closed or was
opened part way
through the cycle.
Ensure the detergent dispenser drawer is fully closed at
the start of the cycle and remains closed throughout the
cycle.
Updated: Thu, 11 Nov 2021 20:34:28 GMT
Powered by
3
