Fig.10 Leveling - Step 7
Completing your Installation
• Turn on the water and check all hose connections for leaks. Make sure there are no kinks in the hoses. Check
the hose connections for leaks again after 24 hours.
• Uncoil the power cord, remove and discard the plastic pin cover, and plug into wall socket and turn the power
on.
Installation Test Cycle
Your washer must be correctly installed before use. Check the machine’s installation and operation using the following
procedure:
1. Touch POWER to activate your washer.
2. Touch both the KEYLOCK and OPTIONS buttons at the same time, and hold for three seconds.
3. Touch START/PAUSE to start the installation test cycle. The display will show and the lid will lock.
4. The machine will beep to signal the end of the installation test cycle. Any faults will be displayed on the screen
(refer to the back of this User Guide to help identify faults). If you need further assistance, please contact a
Fisher & Paykel Customer Care Representative. Refer to page 53 for contact details.
If there are no faults found, the washer will automatically turn off at the end of the
installation test cycle.
Clothes Washer Safety
• This clothes washer is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Updated: Fri, 16 Sep 2022 07:37:44 GMT
Powered by
3
