Leveling
Leveling Instructions
It is IMPORTANT to level the machine to ensure good spin performance and effective detergent and fabric softener
dispensing.
A spirit level is provided with your machine. Use this to level your machine, placing it bottom side down in the locations
specified below (ensure the surfaces are clean). The machine is level when the bubble sits in the center, within the two
lines.
Your washer is equipped with self-locking feet to ensure they do not move once you have leveled your machine. To
adjust the feet, tip the washer back or forward to locate the foot you wish to adjust, pull down gently and then twist to
move it up or down to the required level. Repeat if necessary.
After leveling, the corners of the washer should be clear of the floor (by at least 2/5” (10 mm) and the
machine must not rock in any direction).
1. If not already installed, fit the rubber inserts into
all 4 feet on the base of the machine.
2. Extend all 4 feet by three full turns before
moving the machine to its final position.
3. Move the machine to its final position using the
top corners to maneuver the product into place
(do not push against the center front of the
machine). We recommend a minimum
clearance of 3⁄4” (20 mm) each side and 2” (50
mm) at the rear of the machine.
4. With the lid closed, place the spirit level at the
center back of the lid (near the control panel). If
not level, pull the machine out and adjust the
rear feet until the machine is level side to side
when in position.
Updated: Fri, 16 Sep 2022 07:37:44 GMT
Powered by
1
