479645
16
6
FAULT CODES
Before replacing any components, always check the harness and connections.
Fault Code Short Description
Reason
door open Door detected as not closed. Door has been detected as not being
closed 20 sec after program has
been started.
no tap
Expected water level not
attained within 8 minutes.
Target water level has not been
reached in the allowed time.
E7:00
Wash Motor Error.
The initial speed of the motor has
been detected as being out of sync.
E7:01
Motor Stall Error.
The motor control module has been
unable to start the motor.
E7:02
Motor Loss of Phase.
The motor control module has
detected a loss of a of the phase in
the motor.
E7:03
Motor Over Current.
The motor control module has
detected excessive current.
E7:04
Motor Current Sense Error.
Motor current sensing circuit is faulty.
E7:06
Motor Brown Out.
The supply voltage level has become
too low to power the motor control
module.
E7:07
Motor Winding Over Temp.
Motor control module has detected
the motor windings over temperature.
E7:08
Motor Bridge Over Temp.
Motor control module has detected
that the motor bridge electronics is
over temp
E7:09
M/C Module Self-Test Error. Motor control module during its self-
test routine has detected an error.
Err 10
Heater NTC error which is
displayed at end of program.
The heater NTC circuit has
malfunctioned.
Err 12
Water level has exceeded
flood protection level.
Water level readings found to be
above the flood protection level.
Err 37
Pump error.
The water level has not changed in 6
minutes.
Err 74
Pressure sensor out of range. Pressure sensor frequency is out of
range
