Inlet Hoses
Failure to adhere
to the following
instructions may
result in a flood
and damage to
property.
• New hose sets provided with the washer shall
be used to connect the washer to the water
supply.
• Old hose sets should not be used.
• We recommend replacing the inlet hoses
every 5 years.
• Hoses should be checked from time to time
and replaced if any wear, cuts, bulges, kinks
or leaks are found.
Inlet hose ends
1. Connect the straight ends of the inlet hoses to the taps (there are washers fitted in both ends). Connect the red
connector hose to Hot, and the white connector hose to Cold.
2. Connect the elbow ends of the inlet hoses to the corresponding washer inlet valves. Inlet valves are marked on
the back of the washer. Ensure the Hot valve is connected to the hot tap and the Cold valve is connected to the
cold tap.
H = Hot C = Cold
Cold Water Supply Only:
If you only have a cold water supply, a blanking cap MUST be connected to the Hot inlet valve. The cap prevents water
leaking out of the hot valve. The cap is available from your Fisher & Paykel dealer or Fisher & Paykel trained and
supported service technician, Part No. 388491P. This appliance incorporates backflow protection complying with
AS3500.1. No further backflow protection is required for connection to the water supply.
Updated: Wed, 20 Jan 2021 23:10:07 GMT
Powered by
6
