32
!9
INSTALL BRACKETS TO DOOR PANEL (CUSTOM)
IMPORTANT!
●
●
Ensure the screw pilot holes do not penetrate the full depth of the panel.
●
●
Do not place the handle holes in marked areas to avoid clashing with panel
attachment brackets.
●
●
Minimum panel thickness where screw hole is drilled must be 5/8” (16mm).
Required components/tools:
●
●
Door panel attachment kit
– 6x Side panel brackets
– 6x Bracket slider
– 6x Panel bracket spacer
– 30x M5x12 Cross-head screws (for
Custom door panel only)
●
●
Drill with 3/32” (2.55mm) bit
●
●
Powered driver (Cross-head)
●
●
M4 Hex key (supplied)
5
Mark the centerline from the top of the Custom panel and align with the ‘V’ notch in the
bracket (
D
).
6
Align the screw holes of the bracket with the screw holes of the door panel and fix the
hanging bracket to the door panel with M5x12 Cross-head screws (
E
).
– 6 screws for 18” (457mm)
– 10 screws for 24” (610mm) and 30” (762mm)
Attach the top and side hanging brackets to (Custom) door panel
B
2
Remove the top hanging bracket from the top
of the door and set aside (
A
).
3
Unscrew the adjustment screws by 1/8”
(3mm) to move close to the middle of
adjustment range (
C
).
4
Mark the location of the screw holes and drill
pilot holes to the marked location. Refer to
the custom panel template in the ‘Custom
door panel dimensions’ section.
7
Align the side panel bracket assembly (bracket, slider and spacer) to the screw holes on the
side of the door panel and fix with M5x12 Cross-head screws (
F
).
E
F
F
D
A
1/8”
(3mm)
C
1
Remove the M8 washer and M8 nut from the M8 screws at the top the door (
B
).