3
SAFETY AND WARNINGS
!
WARNING!
8.5 kg
(HP60)
9.5 kg
(HP90)
Weight Hazard
The appliance is heavy. Please ensure adequate care is taken when
installing the appliance to prevent personal injury. The appliance must be
installed onto a solid wall, stud, beam or truss. Weight of the product is
8.5 kg (HP60) / 9.5 kg (HP90).
!
WARNING!
Electric Shock Hazard
Always disconnect the appliance from the mains power supply before
carrying out any maintenance or repairs. Alterations to the domestic wiring
system must only be made by a qualified electrician.
Failure to follow this advice may result in electrical shock or death.
IMPORTANT SAFETY INSTRUCTIONS
WARNING!
When using this appliance always exercise basic safety precautions including
the following:
●
●
Read the entire set of instructions before installing or using this appliance.
●
●
Please make this information available to the person installing the appliance –
doing so could reduce your installation costs.
●
●
Always switch the power off prior to installation, servicing or cleaning of
the rangehood.
●
●
This appliance must be installed and connected to the mains power supply only
by a suitably qualified person according to these installation instructions and in
compliance with any applicable local building and electricity regulations. Failure
to install the appliance correctly could invalidate any warranty or liability claims.
●
●
To comply with electrical safety regulations, the rangehood must be plugged into
a socket near the appliance. The socket must be accessible, or have an accessible
isolating switch, to enable the end user to isolate the rangehood from the power for
the purpose of internal cleaning or maintenance.
●
●
A power outlet should be within 750 mm of the motor assembly and can either be
on the wall, behind the chimney or in the ceiling.
●
●
If the supply cord of this equipment is damaged, it must only be replaced by the
manufacturer, its service agent or similarly qualified person in order to avoid a hazard.
●
●
Ducting accessories are not supplied. All ducting must comply with local requirements
and building codes.
●
●
Attention should be given to ensure that any applicable regulations concerning the
discharge of exhaust air are fulfilled.
