Fisher & Paykel HC120DCXB3, Инструкция по установке/Руководство пользователя, Страница: 14 / 28

12
INSTALLATION INSTRUCTIONS
WARNING!
● ●
This appliance is heavy and requires two persons for unpacking and installation
● ●
Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards.
● ●
Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards
IMPORTANT!
Wear gloves to protect against sharp edges.
The manufacturer is not liable for any damage caused by not following these instructions.
Installation
1
Preparing for installation:
Before installing your rangehood:
● ●
Please read the instructions carefully.
● ●
Unpack the rangehood and check that all functions are working.
● ●
Ensure that the voltage (V) and the frequency (Hz) indicated on the serial plate
match the voltage and frequency at the installation site.
● ●
Check that the area behind the installation surface to be drilled is clear of any
electrical cables or pipes, etc.
● ●
The stainless steel and glass surfaces of the rangehood are very easily damaged
during installation if grazed or knocked by tools. Please take care to protect the
surfaces during installation.
● ●
Protect the cooktop surface below with cardboard, or the like, to prevent damage
occurring whilst the rangehood is being installed above.
● ●
Temporarily mark the height of the bottom of the rangehood and the centre of the
cooktop on the wall according to the information given in the ‘Installation instructions
– Height of rangehood’ section.
● ●
The wall used for mounting the rangehood should have sufficient strength and a
flat surface.
2
Attach chimney brackets and hood mounting screws
● ●
Attach the chimney bracket and upper
chimney bracket (if using the upper chimney)
in the locations shown in Fig.2 and 3. Use
the 30 mm screws and expansion plugs if
attaching to masonry.
● ●
Attach the upper hood mounting
screws in the locations shown in
Fig.2 and 3. Use the 30 mm screws
and expansion plugs if attaching to
masonry. Ensure that there is a 2 mm
gap between the screw head and the
wall – see Fig.1.
2 mm
2 mm
Fig.1