11
Using your dishwasher
2
3
4
1
Fig. 3 Dishwasher control panel
Control panel features
1
On/Off
button
turns the dishwasher on or off
2
Rinse aid indicator light
glows red when the rinse aid levels is low, reminding you to refill the rinse aid. See
‘Using rinse aid’.
3
Start/pause/cancel
button
used to start, pause or cancel a wash programme
4
Digital
display
shows the programme steps, the time remaining until the end of a wash programme and
warning
messages
Running a wash programme
1
Turn on the water tap.
2
Connect the dishwasher plug into the power outlet.
3
Load the dishes. See section ‘Loading the dishwasher’.
4
Check that both the upper and lower spray arms can rotate freely.
5
Add detergent. See section ‘Adding dishwasher detergent’
6
Turn the dishwasher on by pressing the
button.
HELLO
and then
PRESS TO WASH
will show on the display. The illuminated ring around the
button will light up.
7
Check the rinse aid light. If it is red, fill the rinse aid dispenser. See section ‘Using rinse aid’.
8
Start the programme by pressing the
button. (You may have to deactivate the keylock first.
See ‘To deactivate the keylock manually’ for instructions.)
The dishwasher will automatically select the best programme for the particular load.
At the end of the programme the dishwasher will play a tune and the word
END
will
appear on the display.
9
Press
the button to turn the dishwasher off.
10
Turn the water tap off.
11
Disconnect the dishwasher plug from the power outlet.
12
Let dishes cool in the dishwasher for 15 minutes before unloading. Leave the door ajar during
this time to help the dishes dry faster.
Important!
Never leave the door in a fully open position, as this could create a tripping hazard.
