Fisher & Paykel DH9060P, Инструкция по установке/Руководство пользователя

Страница: 12 / 40

10
INSTALLATION INSTRUCTIONS
Draining
The dryer is equipped with a condenser unit which accumulates water during the drying
cycle. This water is collected in the removable water tank located at the top left of the
dryer. The accumulated water must be emptied after each drying cycle. However you
can also set up your dryer to drain automatically using the drain hose provided.
Connecting the drain hose:
1
Remove the black hose from the connection at the back of the dryer (
A
).
2
Uncoil the drain hose (included with your dryer) and connect it to the black hose (
B
).
3
Place the other end of the drain hose into a tub or standpipe.
If you connect the drain hose onto your dryer, the other end must be secured in a drain
to prevent water draining onto the floor. Ensure the drain hose is securely fixed in
place to an appropriate drain and is leak-free at the connection to the machine. Check
the connection and drain hose regularly.
z
Maximum standpipe height is 1m from ground level.
z
Regularly check that your standpipe or tub is free from lint and other obstructions,
which may affect drainage and cause flooding.
z
The drain hose should be checked from time to time and replaced if any damage,
eg wear, cuts, bulges, kinks, leaks, etc are found. Do not bend the drain hose sharply,
as this may cause it to split.
z
The extended length of the provided drain hose is 1.3m.
z
In multi-storey apartments or any upper floor, the machine should be installed on
a floor equipped with a drain.
z
Draining must comply with local by-laws.
A
B