Mounting dryer on wall
1. Determine the position of the dryer on the wall and
mark the bracket position. A minimum of 50mm is
needed between the top of the dryer and the ceiling for
ease of installation. If mounting above a washing
machine, allow sufficient room to open the lid of the
washer. Refer to page 11 for lid clearances.
2. Fix the wall hanging brackets to the wall securely, ie
into the stud. If the studs are too far apart, fit a timber
slat to the studs and then mount the brackets to the
slat. If a slat is used install a second slat behind the
spacers to ensure the dryer is horizontal. The distance
between the centre of each bracket is 555mm (
A
).
3. To install the hooks onto the dryer, remove one screw
from each side (
B
), reuse these screws with two more
(each side) from the kit to fasten the hooks in place.
4. Remove plastic plugs from the back of the dryer and
screw the spacers provided in place (
C
).
5. With assistance, mount the dryer on the wall brackets.
6. Fit inverted control panel over the existing panel.
7. Adjust the display to read correctly on an inverted
panel:
• For DE7060M and DE5060M press and hold the
‘Keylock’ and ‘Heavy’ buttons for three seconds.
• For DE4060M press and hold the ‘Keylock’ and ‘Air
Dry’ buttons for three seconds.
• The dryer will beep to indicate you have made a
correct selection, and the display will change after
three seconds.
• Repeat the same steps to return the panel to the
factory setting.
Before a rear venting option is installed the dryer must be changed from the front venting factory setup. Remove the
outlet grille from the front left-hand side and replace with the outlet cover from the rear left-hand side. These covers
should be gently pried at the sides to prevent damage.
Updated: Sun, 09 Feb 2020 16:40:35 GMT
Powered by
8
