Fisher & Paykel DD24SI9N, Руководство пользователя

Страница: 49 / 60

45
HOW TO ATTEND TO A FAULT (DD*A & DD*C MODELS)
’A’ fault codes
If the display is showing an ‘A’ fault code, follow the steps below to try and fix the issue.
If the fault persists, note down the code before disconnecting the dishwasher from the
water and power supplies and contact Customer Care.
DISPLAY POSSIBLE CAUSE WHAT TO DO

Water supply fault 1 Ensure the water supply is turned on.
2 Press once to stop the beeping, and then
again to clear the fault.
3 Press to resume the wash program.

Drawer cannot drain.
The drainage hose
may be blocked
or kinked, or the
connection to
drainage pipe may
be blocked.
1
Ensure the drainage hose and connection to
pipes are not blocked.
2
Press once to stop the beeping, and then
again to clear the fault.
3
Press to resume the wash program.

The spray arm has
loosened or come
off its mounting, or
water pressure is too
low. 1 Open the drawer and check the spray arm.
2 If the spray arm has loosened or come
off its mounting, re-fit it. Check that it is
firmly seated and turns freely (See “User
maintenance instructions”).
3 Press once to stop the beeping, and then
again to clear the fault.
4 Press to resume the wash program.

Auto recovery
program:
Dishwasher has
detected excess
foam in the drawer. 1 Let the auto recovery program run until it
is complete. The wash program will resume
when the auto recovery program has
completed.
2 Check that you are using the right detergent
before running another wash program.
3 If the drawer is still filled with foam at the end
of the wash program, contact customer care.

(DD*C
models
only)
Sanitize cycle hasn’t
met temperature
needed to sanitize
dishes.
1
Check if the water supply has been turned off
or the wash program interrupted.
2
Press once to stop the beeping, and then
again to clear the fault.
3
Run the sanitize cycle again.