42
FAULT CODES
DISPLAY
POSSIBLE CAUSE
WHAT TO DO
RINSE
+ all modifiers
A1:
Water
Supply fault.
1
Ensure the water supply is turned on.
2
Press once to stop the beeping,
then again to clear the fault.
3
Press to resume the wash program.
ECO
,
RINSE
+ all modifiers
A3:
Drawer
cannot drain. The
drainage hose
may be blocked
or kinked, or the
connection to
drainage pipe may
be blocked.
1
Ensure the drainage hose and
connection to pipes are not blocked.
2
Press once to stop the beeping,
then again to clear the fault.
3
Press to resume the wash program.
1
Ensure the filter is installed correctly.
Refer to 'Replacing the filter'.
2
Press once to stop the beeping,
then again to clear the fault.
3
Press to resume the wash program.
GLASSWARE
,
ECO
+ all
modifiers
A6:
The spray
arm has loosened
or come off its
mounting, or
water pressure
is too low, or a
combination of
low water pressure
and excessive
foaming.
1
Open the drawer and check the
spray arm.
2
If the spray arm has loosened or
come off its mounting, re-fit it. Check
that it is firmly seated and turns
freely. Refer to 'Maintenance'.
3
Press once to stop the beeping,
then again to clear the fault.
4
Press to resume the wash program.
GLASSWARE
,
ECO
+
RINSE
+ all modifiers
A7:
Auto recovery
program –
DishDrawer™
Dishwasher
has detected
excess foam in
the drawer.
1
Let the auto recovery program
run until it is complete. The wash
program will resume when the auto
recovery program has completed.
2
Check that you are using the right
detergent before running another
wash program.
3
If the drawer is still filled with foam at
the end of the wash program, contact
Customer Care.
Current wash p
SANITIZE
A09:
Sanitize
cycle hasn’t met
the temperature
needed to
sanitize dishes.
1
Check if the water supply has
been turned off or the wash
program interrupted.
2
Press once to stop the beeping,
then again to clear the fault.
3
Run the sanitize cycle again.
‘A’ fault codes
Follow the steps below to try and fix the issue.
