FOR CT560X, CT560C, CT5602F, CT2802, CT6551S & BICT602 SERIES COOKTOPS/HOBS
IMPORTANT INFORMATION
Please make this information available to the person
responsible for installing this cooktop as it could reduce
your installation costs.
CAUTION: In order to avoid a hazard, these appliances
must be installed according to these instructions. The
appliance is to be only installed by an authorized person.
NOTE
E
nsure that there is a minimum of 60mm between the cutout and the
rear or side wall.
I
f the cutout is less than 100mm from the wall, some form of
protection against heat should be used, such as ceramic tiles.
T
he CT560X should not be installed directly above a dishwasher as
the humidity may damage the cooktop/hob electronics.
BEFORE YOU START
Do
Ensure the countertop is square and level and ensure no
structural members interfere with space requirements.
Do
Ensure a suitable disconnection switch is incorporated in the
permanent wiring, mounted and positioned to comply with
the local wiring rules and regulations. A means of
disconnection with at least a 3mm air gap contact separation
in all poles must be incorporated into the fixed wiring in
accordance with the wiring rules, unless the local wiring rules
allow for the following variation of these requirements:
A
means of disconnection from the supply having an air gap
separation in all active (phase) conductors must be
incorporated in to the fixed wiring.
Do
Use easy to clean finishes for the wall surfaces surrounding
the cooktop/hob to aid removal of any cooking fume staining
resulting from the use of the cooktop/hob.
Do
Consult local building authorities and by-laws if in doubt
regarding installation.
Do
Ensure that the interconnection cord between the
cooktop/hob and the oven or Control Box is not accessible via
cupboard doors after installation. This applies to any extension
cord as well, even though they are double insulated.
INSTALLATION REQUIREMENTS
If prolonged use is anticipated, or the cooktop/hob is mounted above
a drawer space, a barrier between is recommended
AND
Where the base of this product is accessible, a barrier MUST be
installed to prevent contact.
If a barrier is installed below the cooktop, this barrier must be made
of heat resistant material capable of withstanding sustained exposure
to temperatures up to 70
o
C, be at least 30mm and no greater than
75mm below the base of the cooktop and have FOUR ventilation
holes (min 50mm - max 70mm diameter, see diagram for detail) or
TWO similar holes for the CT2802. These ventilation holes must be
open to free air. It is recommended that the barrier be removable to
allow ease of securing the cooktop with the supplied clamps.
INSTALLATION INFORMATION
Part No. 599100E
03.2006
CURRENT INFORMATION
Current Installation Instructions, Product dimensions and specifications
are available on the
Fisher & Paykel
web site.
www.fisherpaykel.com
