3
IMPORTANT SAFETY INSTRUCTIONS
●
●
Appliances are factory set for Natural
gas but are convertible to LPG. If in
doubt, refer to the local gas network
operator or gas supplier to confirm gas
type at installation site.
●
●
Do not modify this appliance.
●
●
Do not use or store flammable
materials on or near this appliance.
●
●
Do not spray aerosols in the vicinity of
this appliance while it is in operation.
●
●
Packing elements (eg plastic bags,
polystyrene foam, staples, packing
straps etc) and tools should not be left
around during and after installation,
especially if they are within easy reach
of children, as these may cause serious
injuries.
You must remove the transit screws
before installing the cooktop. See step
8 of installation instructions.
Before you install the appliance, please
make sure that
●
●
the local distribution conditions (nature
of gas and pressure) and the adjustment
of the appliance are compatible. For
adjustment conditions for this appliance
see ‘Gas rate summary’.
●
●
a suitable disconnection switch is
incorporated in the permanent wiring,
mounted and positioned to comply with
the local wiring rules and regulations.
A means of disconnection with at least
a 3 mm air gap contact separation in
all poles must be incorporated into the
fixed wiring in accordance with the
wiring rules, unless the local wiring rules
allow for alternative means.
●
●
the appliance is connected to a 220V
- 240V 50Hz (10 A) power supply only
and earthed via the power supply cable.
●
●
there is a power outlet within reach of
the power supply cable (900 mm from
the centre rear of the product). This
must be accessible after installation.
The power supply cable should not
touch any metal parts.
1
SAFETY AND WARNINGS
