damage the paint and plastic surfaces of your dryer.
The SmartTouch
TM
Control Dial (selected models only) is not designed to be removable for
cleaning. Do not attempt to remove the dial.
Pre-treatment Sprays
Do not use pre-treatment sprays or liquids on or near your dryer as they can damage your machine’s control panel as
well as any of its plastic parts. Damage to your dryer caused by pre- treatment products will not be covered by the
limited warranty.
Stains
If stains appear inside the drum of your machine, mix a detergent with water to create a paste (or use a non-flammable
liquid cleaner) and wipe over the stain with a soft cloth. Then dry several wet rags or old towels for 20 to 30 minutes
using the TIME DRY cycle to remove all traces of the cleaner.
Lint filter
Lint is generally formed during wearing and washing. Lint and fibers released
from clothes during the drying cycle are collected in the lint filter.
It is important to clean the lint filter after every load, as the lint produced in the
drying process can become a fire hazard if it is allowed to accumulate in or
around your dryer. AeroCare will flash the “Clean Lint Filter” signal light on the
panel each time you power your dryer on to remind you to clean the lint filter.
Remove the lint filter from the housing and wipe the surface with your fingers.
It is easier to remove the lint when your fingers are moistened. A clean lint
filter will ensure your clothes remain lint-free and your dryer will operate at
maximum efficiency.
Be sure to replace the lint filter before using the dryer.
Fig.58 Cleaning the lint filter
Updated: Tue, 16 Nov 2021 11:31:42 GMT
Powered by
2
